This interactive Sketchup 3D-drawing, of the saw horse shows how the metal rods are protected from accidental contact with the chainsaw blade by using 40mm diameter plastic waste pipe sections.
Once the model is displayed, reveal the NAVIGATION BUTTONS by clicking once on the activate button half way down on the right hand side of the drawing. The function of each button is described below. When you have finished viewing, CLICK HERE to return to the main page.
GENERAL
It is recommended to view the model full screen by clicking the FULL SCREEN button located in the bottom right hand corner of the drawing. Back to top of page. |
With the mouse pointer positioned anywhere on the drawing, rotate your mouse wheel (if present) towards you to zoom out, or in the opposite direction to zoom in.
Left click the HOVER/ORBIT button once, then hold down left mouse button and move the mouse over the drawing to orbit round it. Back to top of page. | |
Left click the PAN button once, then hold down left mouse button and move the mouse over drawing in desired direction to pan up, down, left or right. Back to top of page. | |
Left click the ZOOM IN/ZOOM OUT button once, then hold down left mouse button and move the mouse over drawing towards the top to zoom in, & towards the bottom to zoom out. Back to top of page. | |
Left click the ZOOM OUT button once, which will immediately zoom out of the drawing. Back to top of page. |
When you have finished viewing, CLICK HERE to return to the main page.